This is the model generator for binkat .
Any changes you make are saved in the URL, so you can share that URL or create a bookmark to keep those changes around.
Other generators:
coin-cells ,
cylindrical-cells ,
kraftform-micro ,
wera-l-key
$fn
cell_ diameter
Diameter of each coin cell
cell_ height
Height of each coin cell
cell_ gap
Target gap between cells, in mm
cell_ grab_ length
How much of the cell should stick out of the bin to grab onto? 0.35 means 35% should stick out
recess
How far should the cell be recessed into the box? Setting this to the same or a higher value as cell_grab_length makes the bin stackable.
min_ label_ height
Minimum space for the label that is kept clear of cells
gridx
number of bases along x-axis
gridy
number of bases along y-axis
gridz
bin height. See bin height information and "gridz_define" below.
half_ grid
Half grid sized bins. Implies "only corners".
gridz_ define
How "gridz" is used to calculate height. Some exclude 7mm/1U base, others exclude ~3.5mm (4.4mm nominal) stacking lip.
height_ internal
Overrides internal block height of bin (for solid containers). Leave zero for default height. Units: mm
enable_ zsnap
snap gridz height to nearest 7mm increment
include_ lip
If the top lip should exist. Not included in height calculations.
only_ corners
only cut magnet/screw holes at the corners of the bin to save uneccesary print time
refined_ holes
Use gridfinity refined hole style. Not compatible with magnet_holes!
magnet_ holes
Base will have holes for 6mm Diameter x 2mm high magnets.
screw_ holes
Base will have holes for M3 screws.
crush_ ribs
Magnet holes will have crush ribs to hold the magnet.
chamfer_ holes
Magnet/Screw holes will have a chamfer to ease insertion.
printable_ hole_ top
Magnet/Screw holes will be printed so supports are not needed.
enable_ thumbscrew
Enable "gridfinity-refined" thumbscrew hole in the center of each base: https: www.printables.com/model/413761-gridfinity-refined