This is the model generator for binkat .
Any changes you make are saved in the URL, so you can share that URL or create a bookmark to keep those changes around.
Other generators:
coin-cells ,
cylindrical-cells ,
kraftform-micro ,
wera-l-key
$fa
$fs
tolerance_ short_ arm
Extra length for the short arm of each wrench
tolerance_ short_ arm_ last
Extra length for the short arm of the last wrench. Note that if this is too high, the wrench diameters will shrink to compensate!
tolerance_ main_ arm
Extra length of the main arm of each wrench. This ends up as a gap to the south side of the bin
drop
How far to drop the wrench. The first value is the north drop, the second value the south drop. Different values for north and south lead to the wrenches being placed at an angle. For example, with 4mm north drop and 1mm south drop, the wrenches will be angled so that the south side will point slightly upwards.
press_ pocket
Dimensions of the pocket at the bottom of the bin, which is used to press down on a wrench to take it out. First value is height, second value is depth.
stackable
Should the bin be stackable?
gridx
number of bases along x-axis
gridy
number of bases along y-axis
gridz
bin height. See bin height information and "gridz_define" below.
half_ grid
Half grid sized bins. Implies "only corners".
gridz_ define
How "gridz" is used to calculate height. Some exclude 7mm/1U base, others exclude ~3.5mm (4.4mm nominal) stacking lip.
height_ internal
Overrides internal block height of bin (for solid containers). Leave zero for default height. Units: mm
enable_ zsnap
snap gridz height to nearest 7mm increment
include_ lip
If the top lip should exist. Not included in height calculations.
only_ corners
only cut magnet/screw holes at the corners of the bin to save uneccesary print time
refined_ holes
Use gridfinity refined hole style. Not compatible with magnet_holes!
magnet_ holes
Base will have holes for 6mm Diameter x 2mm high magnets.
screw_ holes
Base will have holes for M3 screws.
crush_ ribs
Magnet holes will have crush ribs to hold the magnet.
chamfer_ holes
Magnet/Screw holes will have a chamfer to ease insertion.
printable_ hole_ top
Magnet/Screw holes will be printed so supports are not needed.
enable_ thumbscrew
Enable "gridfinity-refined" thumbscrew hole in the center of each base: https: www.printables.com/model/413761-gridfinity-refined